Advantech AIMB-766 Instrukcja Użytkownika Pobierz pdf (Strona 15)

7 ACP-1010 User Manual

Chapter 2 System Setup

2.3 Installing the Backplane and the CPU Card

ACP-1010 accepts a 3-slot backplane. To install the backplane, refer to the figures

and proceed as follows:

1. Remove the backplane (T-bar) holder and then fix the backplane onto it with

screws. (Figure 2.2)

2. Insert the CPU card (with CPU, cooler, RAM and necessary cables installed)

into the slot on the backplane. Then fasten the card guide with screws. (Figure

2.3)

3. Insert the PCI/PCIe add-on card to the proper slot on the backplane and then

fixed it solidly.

4. Carefully replace the whole kit into the chassis and fasten it with the screws pro-

vided.

5. Plug in the 20/24-pin ATX power connector and +12 V power connector from the

power supply, also the 9-pin USB connectors from the front panel of the chassis.

6. Connect the POWER SW, RESET SW, LAN LED from chassis to the backplane

and HDD LED cables from the alarm board to the backplane.

Figure 2.2 Installing a backplane

Note! To ensure the best air flow inside the chassis, choosing a CPU cooler

which is lower than 22 mm is highly recommended.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 41 42

Brak uwag

Advantech AIMB-766 Instrukcja Użytkownika Strona 15