Advantech IPC-623 Series Instrukcja Użytkownika Pobierz pdf (Strona 18)

IPC-623 User Manual 12

2.3 Installing the Backplane

IPC-623 supports backplanes of up to 20 slots. To install the backplane,

please refer to Figure 2.3 and proceed as follows:

1. Unscrew the 4 screws located on both sides of the hold-down clamp,

then pull out the clamp.

2. Remove the EMI shield by loosening the six screws.

3. Put the backplane in the proper location and then fasten it onto the

chassis.

4. Connect the 20-pin ATX power connector from the power supply to

the backplane.

Figure 2.3: Installing the backplane

2.4 Installing CPU card & add-on cards

IPC-623 supports up to 20 add-on cards. To install a CPU card or add-on

cards, please proceed as follows:

1. Remove the top rear chassis cover and hold-down clamp. Please refer

to section 2.2 and 2.5 for details.

2. If the thermal sensor becomes an obstacle for installing the card, adjust

the sensor location by loosening its screw. Please refer to Figure 2.4.

Later just return the sensor back to its original location after complet-

ing the cards’ installation.

EMI Shield

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 45 46

Brak uwag

Advantech IPC-623 Series Instrukcja Użytkownika Strona 18