Advantech ACP-4320 Instrukcja Użytkownika Pobierz pdf (Strona 39)

7. Plug the ATX power connector and +12V power connector to the

backplane/motherboard, as well as the hard disk drive and floppy

drive and the peripheral power connectors to the proper disk drives.

8. Replace the hold down clamp and fix it with the two screws.

9. Replace the top cover and then plug in the power cord.

3.4.2 Replacing the Redundant Power Supply Module

Figure 3.6: Replacing the power supply module

1. Turn off the power switch of the failed power supply module.

2. Un-plug the power cord from the failed module.

3. Loosen the screw on the failed module and then grab the handle to

gently pull it out.

4. Make sure that the new module is the same rating as the damaged one.

5. Slide the power supply module inward until it locks into the right posi-

tion.

6. Secure the screw and replace the handle. Then plug the power cord

and turn on the power switch on the new module.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 47 48

Brak uwag

Advantech ACP-4320 Instrukcja Użytkownika Strona 39