Advantech PCL-740 Dokumentacja Pobierz pdf (Strona 15)

Chapter 2 Hardware Installation 11

Default Settinos

The board will be shipped in the RS-232 mode, the jumpers on the

10*3 pin jumper will be set to the upper position, this is the cards

default setting. If your requirements are the same as the default

settings, you may simply install the card without the need for any

setting up. The PCL-741 DIP switch and jumper default settings are

as j; shown below:

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 25 26

Brak uwag

Advantech PCL-740 Dokumentacja Strona 15